makes the minute hand go round but not the hour hand. The process is simple, Pull the dial, lift the hour wheel, pull the canon pinion off, stick a small broch in the canon pinion, take side cutters to the side of the canon pinion and give it a little pinch, reassemble and your done. To remove the hands, carefully pry upwards and all of the hands should pop off. If you have a second hand, grab it where it attaches to the clock motor and pull up, or away from the clock movement. Behind the minute hand is a small, raised area that is called the hand bushing. In order to not accidentally scratch the face of your watch, place a piece of paper under where you will be prying up the hands. How can I fix the hour hand. The problem of the hour and minute hands not moving while the second hand does is most likely linked to a worn offset cannon pinion wheel. The message Alignment Complete appears. Natalee Paterson - I have reset the watch and unpaired and paired the watch in bluetooth but my hour hand does not move. If your moon dial does not show the correct phase of the moon, determine the date of the last new moon . Re-tighten your nut using small pilers. joseph john - the second hand works. Thank you. my new coutura kinetic perpetual minute and hour hands stopped working. After flying seven time zones, I pulled the stem and turned the hands seven hours forward but, when I looked at the watch, the hour hand had not moved correctly and is now half an hour off. As you likely know, most places remove the works, stick them in an agitating solution, and call it cleaned. It rotates quickly (once every minute). • The center hex nut could be too tight - if your clock is running slowly you can loosen this about a quarter turn. I have also gone in to calibration and can calibrate the minute hand but still can't get the hour hand to move. I’m using Seiko Sportura ,and i love its kinetic movement.I just recommend this watch. It is secured by pressing a hollow stem on the underside of the second hand into a ball joint at center of the pinion, locking the three hands in-place. In the analog clock, the minute hand is on "14" minutes, and the hour hand is moving from "12" to "1" - this indicates a time of 12:14. Virtually all clocks have an hour hand (the short one) and a minute hand (the long one). Or measure the angle of the second hand from 12 o'clock. The bottom of the minute hand cannot be rubbing the hour hand tube or the hour hand. Re-attach the minute hand to the clock. It still worked, but it was important to him that the second hand moved. Either way , it's a 1 minute fix. When the minute hand reaches the quarter hour, the clock chimes, and the right hand weight drops. So after running out of power due to being not used for a few days, I rewound and set the time on my Breitling Navitimer TT replica but to my dismay it no longer runs. Now, after keeping good time for about 4 hours, the minute and hour hands cease moving, but the second hand keeps going. Be careful handling the hands because they can be very fragile. Then do the same for the second hand. For a better experience, please enable JavaScript in your browser before proceeding. Align the minute hand with the 12 O'clock position. If it doesn’t start moving again on its own, put the battery in backwards for a few seconds and then return it to normal. Some people love fixing timepieces. If it is, gently push the hand toward the dial just enough so that it clears the glass. I am having my first ever issue with it. While applying pressure, pull the stem out and it should freely come off.